|
|
Post by wankedah on Sept 9, 2008 9:30:28 GMT 8
Spark plug (standard) - NGK CR8EH-9 or equivalent
Spark plug (racing) - NGK CR9EH-9 or equivalent
Spark plug gap - 0.8-0.9mm
|
|
|
|
Post by wankedah on Sept 9, 2008 9:31:47 GMT 8
will try the honda wave plugs
i bought
CPR9EA-9
if the plugs are wrong.. what will happen??
|
|
|
|
Post by zul_cbr on Sept 9, 2008 12:37:13 GMT 8
will try the honda wave plugs i bought CPR9EA-9 if the plugs are wrong.. what will happen?? haiya...manyak degil ini worang.... ;D ;D nan, just give it a try. aku rasa boleh jer tu. "Using the wrong spark plug will also do it also. If you are not using the plug specified in your owner's - manual, you might have problems.
When a spark plug gets too hot, the insulator may boil and bubble On examination, it will be plain that it has been too hot. Also, the metal electrodes may melt away and disappear. If any of these bad things happen, that's good.
The worst result of a too-hot plug that fails-to destroy itself, is when it destroys the engine instead; this is called pre-ignition. If the tip of the plug becomes hot enough to ignite the fresh mixture being drawn into the cylinder, then the incoming mixture will start to burn without waiting for the spark to happen."CPR9EA-9 (nan) / CR8EH-8 (oem) C- thread diameter sama PR - Projected Insulator Type (P) + Resistor Type (R) 9- degree of hotness dah ok la tu. E- thread reach sama A- special design (lagi bagus agaknya) 9- wide gap. yg ni aku risau sbb beza 0.1mm dgn yg oem. apapun, try la dulu. |
|
|
|
Post by wankedah on Sept 9, 2008 15:43:57 GMT 8
ok aku dah tukar spark plug tuh mula2 motor boleh start, dok warming up ok, lepas tu mati pulak... aku tarik cable choke (bawah tank)... start balik ok .. lepas tu aku lepas , mati balik... sekarang tak mau start balik...  pening aku...tolong |
|
|
|
Post by zul_cbr on Sept 10, 2008 14:26:15 GMT 8
ok aku dah tukar spark plug tuh mula2 motor boleh start, dok warming up ok, lepas tu mati pulak... aku tarik cable choke (bawah tank)... start balik ok .. lepas tu aku lepas , mati balik... sekarang tak mau start balik... pening aku...tolong ermm...aku btol2 saspek valve seal la nan. skrg mcm mana? ko pun bz. hantar ke kedai je lah solutionnya. |
|
|
|
Post by wankedah on Sept 17, 2008 21:26:37 GMT 8
dah hantar.. esok aku pi follow up...
aku buat top overhaul
|
|
